Overview
This article mainly explains how to configure repeater mode on the FTA1101.
The Repeater mode is a feature of gateways that allows them to extend the coverage area of an existing network.
The FTA1101 can act as a relay station, receiving and retransmitting signals from the main network to areas with weak or no coverage.
Topological diagram
Configuration steps
1. Physical connection
Connect the LAN port of the FTA1101 to a computer with an Ethernet cable, connect the Phone port to an analog phone. When correctly connected, the adapter light will be solid red, the computer will receive an IP address (192.168.1.X) from the adapter.
2. Log in to the adapter management page
Open a browser and enter the LAN IP address of the adapter 192.168.1.1 in the address bar, a login page appears as shown below, the default username and password are admin. Then click Connect.
Note: If you cannot open the page 192.168.1.1 with your browser, this is usually caused by an IP address conflict with the WAN IP. In that case, open the page 192.168.2.1 instead.
3. Go to Wireless > Basic Page, change "Wireless Connection Mode" to Repeater, configure the SSID of FTA1101, click "Save".
4. Go to the Wireless > Repeater page, connect to the router’s SSID.
Select the SSID, enter the password, click OK
5. Go to Administration > Operating Mode page, change the Operating Mode to "Advanced Mode", click "Save & Apply".
6. Go to Network > LAN, enable the local DHCP server and click “Save & Apply”
7. Go to Network > WAN, enable NAT and click "Save"
8. Restart FTA1101
Connection test
Wireless clients, such as IP phones and mobile phones, can connect to the FTA1101 Wi‑Fi to browse the Internet.
Connect an analog phone to the FXS port of the FTA1101. After the analog phone registers on a PBX server, the analog phone can make calls.
How to register on FTA1101 : flyingvoice.com
