This article primarily presents two cases for configuring the adapter to access the Internet and register with the SIP server. Case 1 for using a wired connection to obtain Internet, case 2 for using a wireless connection to obtain Internet.

Case 1 Using an Ethernet cable to obtain Internet

Step 1. Physical connection


Connect FTA1101 WAN/LAN port to the Ethernet cable to access the Internet, connect the LAN port to a Computer with another Ethernet cable. When it is correctly connected, the adapter LED will be solid red, the computer will receive an IP address (192.168.1.X) from the adapter.

Step 2. Log in to adaptermanagement page of

Open a browser and enter the LAN IP address of the adapter 192.168.1.1 in the address bar, a login page appears as shown below, the default username and password are admin. Then click Connect.

Step 3. Check the network status

L'adaptateur obtiendra automatiquement l'adresse IP WAN, ce qui signifie que l'Internet fonctionne sans aucun réglage. Vérifiez l'état du réseau sous Statut > Basique > État du réseau.

Step 4. Register to PBX server

Connect the analog phone to the phone port of the adapter, go to SIP Account>Line 1, enable the Line Activation option, enter the Proxy Server, Proxy Port, Display Name, Phone Number, Account and Password, then click Save & Apply at the bottom of the page.


Lors de l'enregistrement réussi au serveur PBX, le voyant LED de l'adaptateur passera à vert solide, et le statut du compte SIP s’affiche Enregistré. Le téléphone analogique peut passer des appels sortants ou recevoir des appels entrants

.

After confirming the call works, you can disconnect the cable from the PC to the LAN port of the FTA1101.

Case 2 Using wireless connection to access the Internet

Step 1. Physical connection

Connect the FTA1101 LAN port to a computer with an Ethernet cable, connect the Phone port to an analog phone. When properly connected, the adapter LED will be a solid red, and the computer will receive an IP address (192.168.1.X) from the adapter.

Step 2. Log in to adaptermanagement page of

Ouvrez un navigateur et saisissez l’adresse IP LAN de l’adaptateur 192.168.1.1 dans la barre d’adresse, une page de connexion s’affiche comme ci‑dessous, le nom d’utilisateur et le mot de passe par défaut sont admin. Puis cliquez sur Connexion.

Note: If you cannot open the page 192.168.1.1 with your browser, it is usually caused by an IP address conflict with the WAN IP. In that case, open 192.168.2.1 instead.

Step 3. Configurethe adapter’s Wireless Connection Mode

To ensure the adapter gets Internet access, we must change the adapter's wireless mode to repeater. Go to Wireless > Basic, enable the Radio, change the Wireless connection mode to Repeater, configure an SSID (wireless network name). Click Save at the bottom of the page.


Go to Wireless > Repeater, the wireless connection status is Disconnected. Select the wireless network you want to connect to, click Connect, enter the password and click OK

.

When the adapter connects to Wi‑Fi successfully, the wireless connection status changes to Connected. And display the SSID you are connected to.

Step 4. Register on the PBX server

Connect the analog phone to the phone port of the adapter, go to SIP Account>Line 1, enable the Line Activation option, enter the Proxy Server, Proxy Port, Display Name, Phone Number, Account and Password, then click Save & Apply at the bottom of the page.

Upon successful registration to the PBX server, the adapter’s LED will turn to solid green, and the SIP account status displays Registered. The analog phone can make outgoing calls or receive incoming calls.

After confirming that the call works, you can disconnect the cable from the PC to the FTA1101 LAN port.