(1) The two main access points and repeaters must support WDS, all must use Flyingvoice WiFi routers.
(2) In WDS mode, the VoIP/TR-069/provisioning function cannot be used if the slave AP’s WAN port is not connected.
WDS network structure.
6.png7.png
Configuration method :
(1) Configure WDS mode, a single access point can be set to Lazy mode.
0: Disable – Disable all WDS functions.
1 : Bridge mode — Enable the WDS function, WDS peer access points are listed by MAC address in the "WdsList" field below. In this mode, the access point does not send a beacon and does not process probe request packets, so the STA cannot connect to it.
2 : Repeater mode - Enable WDS function, WDS peer access points are based on the MAC address listed in the "WdsList" field below.
Primary AP, enable LAN DHCP server.
8.png
AP WDS, disable LAN DHCP server
9.png
3 : Lazy mode – Enable WDS function and auto‑learning from the WDS packet containing the addr4 field.
(2) Set the same Phy/EncrypType/EncrypKey mode for both APs
(3) Configure both access points on the same wireless channel, the automatic channel cannot be used.
(4) To support automatic roaming between two WDS repeater access points, both APs must be configured with the same SSID and security key.
(5) Disable the slave AP’s DHCP server and change the default LAN IP address of an AP to avoid IP conflicts.
(6) The "AP MAC Address" must be set as the BSSID of the paired access point in Repeater/Bridge wds mode.
10.png