Overview of the configuration:
Due to significant hardware appearance differences between Flyingvoice intercom devices and SIP phones, factory reset methods are also different. Flyingvoice intercom devices reserve a physical Reset button for factory reset operations. In addition, this button also supports other functions depending on different usage scenarios.
Test devices:
1 × i86-01 dispositif d’interphone
1 × intercom device i11V
1 × i86‑PCBA
Applicable models :
This guide applies to all Flyingvoice intercom devices.
1. In some situations, when the loudspeaker device cannot be configured via Wi‑Fi or the WAN IP address, you can use the external Reset button to restore factory settings. The following examples use the i86-01 and i11V models.
2. The figures below show the i86-01 and i86-PCBA devices.


① : Enable Wi‑Fi function
Remove the cover before using the i86‑01 device. You will find a small reset hole. When the device is operating normally, press the reset hole once with a thin tool. This will activate the device’s Wi‑Fi function. Once Wi‑Fi is enabled, connect your PC or mobile phone to the device’s SSID, then access the web configuration page via :192.168.15.1
② : Factory Reset
If the i86-01 cannot be accessed by any means, you can perform a factory reset by following these steps:
(1). Press and hold the reset hole with a pointed tool.
(2). Reconnect the power or PoE cable to restart the device.
(3). Continue de maintenir le bouton Reset pendant 5–10 secondes au démarrage.
(4). After hearing the sound "beep‑beep‑beep", the device factory reset is successfully completed.
3. For the i11V model, use the screwdriver provided in the package to remove the front panel and access the internal structure.

4. The Reset button of the i11V is located on the rear side of the PCB, facing the aluminum case. When enabling Wi‑Fi or performing a factory reset, use an appropriate tool to press and hold the Reset button as shown below.

