نظرة عامة على التكوين:

Due to the significant differences in appearance between Flyingvoice intercom devices and IP phones, factory reset methods also differ. Flyingvoice intercom devices retain a physical Reset button for factory reset operations. In addition, this button supports other functions depending on different usage scenarios.

أجهزة الاختبار:

1 × i86-01 جهاز النداء الصوتي

1 × جهاز i11V للنداء الصوتي

1 × i86-PCBA

النماذج القابلة للتطبيق:

This guide applies to all Flyingvoice intercom devices.

1. في بعض الحالات، عندما لا يمكن تكوين جهاز النداء الصوتي عبر Wi‑Fi أو عنوان IP WAN، يمكنك استخدام زر Reset الخارجي لاستعادة إعدادات المصنع. الأمثلة التالية تستخدم نماذج i86-01 و i11V.

2. The figures below illustrate i86-01 and i86-PCBA devices.

①:تمكين وظيفة Wi-Fi

Remove the front cover of the i86‑01 device. You will find a small reset hole. When the device is operating normally, press the reset hole once with a pin. This will enable the Wi‑Fi function on the device. After enabling Wi‑Fi, connect your computer or mobile phone to the device’s SSID network, then access the web configuration page at: 192.168.15.1

②:إعادة ضبط المصنع

إذا تعذر الوصول إلى i86-01 بأي طريقة، يمكنك إجراء إعادة ضبط المصنع باستخدام الخطوات التالية:

(1). اضغط مع الاستمرار على فتحة إعادة الضبط بأداة دبوس.

(2). Reconnect the power source or PoE cable to restart the device.

(3). Continue pressing the Reset button for 5–10 seconds during startup.

(4). After hearing the "beep-beep-beep" sound, the device factory reset completes successfully.

3. بالنسبة للطراز i11V، استخدم أداة المفك المضمنة في العبوة لإزالة اللوحة الأمامية والوصول إلى الهيكل الداخلي.

4. The i11V Reset button is located on the rear side of the PCB, facing the aluminum frame. When enabling Wi‑Fi or performing a factory reset, use an appropriate tool to press and hold the Reset button as shown below.