[Problem Description]
Users do not know how to sync the phone’s system time or want to manually change the time and date.
[Debug Instructions]
1. The time and date are displayed on the waiting screen of the SIP phone. You can set the time and date manually or obtain them automatically via the network using an NTP server.
2. You can also enable the phone to obtain the SIP server time.
Change the time settings on the WEB interface
Press OK or choose Menu > Status to display the IP address. Then enter the phone’s IP address to connect to the WEB page. The default account and password are admin/admin. As illustrated below:

Method 1: sync time with NTP server
Go to Administration > Management > Date/Time Settings, enable NTP (it is enabled by default), select the correct time zone, change the primary NTP server (optional) and the secondary NTP server (optional), configure NTP synchronization (optional), then click Save & Apply at the bottom of the page to save the settings.


Note: if the NTP server is a public network address, the phone must be able to access the Internet, otherwise time synchronization will fail.
Method 2 Configure the time manually
Set the time/date manually. As shown in the image below:

Disable "NTP Enable", manually enter the time/date in "Current Time", then click Save & Apply at the bottom of the page.
Note: with this method, the time will revert to the default value when the phone restarts.
Method 3: sync time with SIP server
This function must be supported by the SIP server, and the phone's time sync switch is enabled.
Go to SIP Account > Line1 > Advanced SIP Configuration, enable time synchronization, then click Save & Apply at the bottom of the page.


Then you can check if the time is correct on the phone.
Adjust the time settings on the phone's LCD screen
On the idle screen, navigate to Menu > Basic > Time & Date. As shown in the image below:



Method 1: sync time with NTP server
Select SNTP, then enter the NTP server address, choose the time zone and time format, then press OK to confirm the setting.

Method 2 Configure the time manually
After entering the time and date, select General and press < > to choose Manual. Then set the time manually, set the date, time format and date format, then press OK to finish configuration.

