Reason for Firmware update failure
During firmware updates, external factors such as "power failure" or "network disconnection" can cause the update to fail. If the firmware download is incomplete due to a "network disconnection", you can restart the phone and update again. If a power outage occurs during the update, i.e., when the firmware download is finished and the phone is in the middle of a "Firmware Upgrade", the phone will enter a rescue mode after reboot; in this mode, the phone cannot be used normally, but you can recover it using the update method in SECURITY MODE.
How to check the BACKUP MODE settings?
When the phone switches to backup mode, the following settings will be displayed on the phone screen.

ID VLAN : If there is a VLAN in the current network environment, the phone will obtain the corresponding VLAN ID to receive the IP address of the corresponding network segment.
Wan : The internal network IP address obtained by the current phone; you can connect to the phone’s web interface with this address in the same network environment.
LAN: when the phone switches to standby mode, it activates DHCP; you can connect a computer to the phone’s LAN port, it will obtain an IP address in the 192.168.1.X range, then you can connect to the phone’s web interface at 192.168.1.1:80.
How to retrieve the phone ?
Method 1. Connect with the WAN IP address and retrieve
Check the WAN IP address on the phone’s LCD screen, then enter this address in the web browser’s address bar; a password prompt will appear, enter "admin", then click Connect to log in.

1. After logging in, you can see the basic phone information on the "status" page.

2. Go to the "Upgrade" page to update the firmware again.

Method 2. Log in with the LAN IP address and retrieve
1. Connect the computer to the phone's LAN port with an Ethernet cable, then access the phone's web interface with the LAN IP 192.168.1.1:80.

2. Go to the "Upgrade" page to update the firmware again.

