The Flyingvoice VOIP router differs from traditional routers. It is a full‑featured wireless VOIP router that integrates an FXS interface, an SFP interface, a 4G‑LTE module, etc., in addition to classic NAT router functions. This article primarily presents how to configure the router to access the Internet and register with the SIP server.

This article applies to FWR8102, FWR9601, FWR7102, FWR7302

Step 1. Physical connection

If you use the Ethernet cable to access the Internet, connect the Ethernet cable to the router’s WAN port, then connect one of the router’s LAN ports to a computer.



Si vous utilisez la fibre optique pour accéder à Internet, connectez le câble fibre au port COMBO du routeur, and connect one of the router's LAN ports to a computer.


If you use a SIM card to get Internet, insert the SIM card into the router, and connect one of the router’s LAN ports to a computer.

Step 2. Log in to the router management page

Open a browser and type the router’s LAN IP address 192.168.1.1 in the address bar; a login page appears as shown below, with the default username and password being admin.

Step 3. Configure the WAN Connection

Go to Statut >Basique >État du port WAN Ethernet pour vérifier l’adresse IP WAN. Lorsqu’une adresse IP WAN est présente, cela signifie que le routeur fonctionne.

Remarque : si vous utilisez une carte SIM pour accéder à Internet, vérifiez l'état LTE sur cette page ; lorsqu'une adresse IP apparaît sous l'état LTE, cela signifie que le routeur fonctionne.

Step 4. CCustomize wireless settings

Go to Wireless 2.4 GHz or Wireless 5 GHz > Basic to change the router SSID (wireless network name).

Go to 2.4 GHz Wireless or 5 GHz Wireless > Wireless password to change the wireless password.

Step 5. Register on the PBX server

Connect the analog telephone to the Phone 1 or Phone 2 port of the router, go to FXS1 or FXS2> SIP Account, enable "Line Enable", enter the proxy server, proxy port, display name, phone number, account and password, then click Save & Apply at the bottom of the page.

When the recording to the PBX server succeeds, the router phone LED lights up, and the SIP account status shows Registered. The analog phone can make outbound calls or receive inbound calls.