On the VOIP phone, the account (extension number) is comparable to the mobile phone’s SIM card. Registering an account facilitates receiving an inbound call or dialing an outbound call. This article explains how to register an account on the IP622CW.

Step 1. Network connection

IP622CW supports wired and wireless connections.

When using wireless connection, please refer to the instructions below.

1) Press the Settings button , go to Wireless-> Wireless connection.

2) Select a wireless network and connect to it.

When using a wired connection, please refer to the instructions below.

Connect the router or switch to the phone’s Internet port with an Ethernet cable.

Note: If the phone could not obtain an IP address, refer to the appendix to manually configure the IP address.

Step 2. Account registration

There are two ways to register the account on the phone.

Method 1: via the phone management page

Note: Before configuration, the PBX server administrator must provide the following registration information: domain name or server IP address (e.g., 192.168.20.110), port number (5060), account number (600), account password (password600).

1) Check the phone’IP address

Press the hold button to verify the phone's IP address.

2) Connect to the phone management page.

Enter the phone’s IP address in the web browser address bar, then enter the username and password to log in (the default username and password are “admin”).

3) Enter registration information.

Click SIP Account → Line1, enable the Line, enter the Proxy Server, Proxy Port, Display Name, Phone Number, Account and Password, then click Save & Apply.

Hold on a moment, the phone will be successfully recorded, you will see the recording status change to Recorded, the phone screen displays the extension number, and the line button lights up green.

Method 2.via the phone's LCD screen

Press the Settings button , navigate to Accounts (the default password is admin)->Line 1, Activate the line, enter the password, account, display name, phone number, SIP Proxy server (domain name or server IP address) and SIP Proxy port, then press Save.

Appendix

Cconfigurer une adresse IP statique sur le téléphone’s écran LCD

Press the Settings button , access Network → Connection type, change the mode to static IP, enter the IP address, mask, gateway, primary DNS and secondary DNS, then press OK.