The FIP16/FIP16Plus supports IEEE802.11K/R Fast Roaming, allowing you to move during a conversation without interruption. This guide explains how to test this feature.

EEquipment Rerequired

1. Two access points (AP‑1 and AP‑2)

2. Two SIP phones (FIP16-1 and FIP16-2)

KeyPointfor Rroaming

1. The SSID (wireless network name) is identical.

2. The wireless encryption type is the same.

3. The IP address is the same. (The phone gets the same IP address when it moves to another network)

4. Two networks have overlapping zones.

Procedure

1. Configurez un SSID sur deux points d’accès, assurez‑vous que tous les paramètres sont identiques sauf le canal.

2. Placez ces deux points d’accès et assurez-vous que les deux réseaux ont des zones de recouvrement ; il sera préférable que la force du signal dans cette zone soit comprise entre -60 dBm et -65 dBm.

3. Standing a few feet from the FIP16-1 near the AP-1, ensure that the FIP16-1 is associated with the AP-1.

4. Dial the FIP16-2 number from FIP16-1.

5. Walk to AP-2 until you are directly next to FIP16-1, then check which AP you are connected to.

How to know if FIP16/FIP16Plus does roaming successfully?

1. The call was not interrupted during the test.

2. FIP 16-1 is paired with AP-2 at step 5.

How to check which access point you are connected to to?

Method1: Go to Menu > Status > Network, it displays the SSID and MAC address of the access point.

Mmethod 2: Log in to the AP management page or the AC controller management page to verify which device is connecting to its network.

What to do if the phone takes time to switch Wi‑Fi?

1. Check signal strength in the overlap areas between two access points.

Move the phone to overlapping zones, go to Menu > Status > Network, the number at the top of @ is the signal strength.

2. Adjust the threshold value on the phone.

Note : The Wi‑Fi signal strength varies randomly, you can test the signal strength multiple times, try a few additional thresholds, and keep the optimal value.

For FIP16Plus :

Go to Menu > Basic > Wi‑Fi > Wi‑Fi Configuration > Signal Strength. Change the value to the signal strength you confirmed in step 1.

For FIP16:

Method 1 : Export the configuration file (cfg format) including this parameter: RoamThreshold=X (X is the signal strength you previously confirmed. For example, RoamThreshold=65, means the signal strength is -65 dBm.)

Méthode 2 : Telnet vers le téléphone, exécutez cette commande : nvram_set RoamThreshold X (X est la force du signal que vous avez confirmée auparavant. Par exemple, nvram_set RoamThreshold 65.

3. Adjust the short interval value on the phone

Go to Menu > Basic > Wi‑Fi > Wi‑Fi Configuration > Short Interval, decrease the short interval, change it to 3 s or 2 s.

4. Check the phone's firmware version, ensure it is the latest.