Overview

1. Basic Introduction IPSec (Internet Protocol Security) is a common security protocol on the Internet. It is the most widely used security protocol standard in the development of VPN technologies and various network security solutions. It offers a wide range of mechanisms and strong security. 2. Application
181.png
An underlying issue between IPSec tunnels and dynamic routing protocols is that dynamic routing relies on multicast or broadcast packets for routing scope notification, while IPSec tunnels do not support encryption of multicast or broadcast packets. Our company proposed a solution to this problem by adopting the combination of GRE and IPSec to simplify configuration.
Device GRE configuration:
Device 1
182.png
Device 2
183.png
Parameter Description
VPN enabled Enable VPN, select GRE
GRE tunnel name Enter the tunnel name
Remote IP Enter remote IP
Local IP Enter local IP
Local tunnel IP Enter the local tunnel IP
Remote tunnel IP Enter the opposite tunnel IP
Remote destination Fill in the destination segment
IPSec configuration
184.png
Parameter Description
IPSec connection Select the name of the IPSec connection or create a new IPSec
Connection name Enter the IPSec connection name
Activate IPSec Enable IPSec
Interface 20171220041059922.pngSelect the connection type for IPSec
IPSec network type Choose IPSec network mode, there are two options, one is the site‑to‑site path, the other is remote access.
Authentication type The authentication type here can only be the pre‑shared key option
PSK Enter a password; the remote and local passwords must be identical
Local ID type Choose one of the three types Default / FQDN / ID as local ID
Local WAN IP/FQDN Enter the local device WAN address
Remote ID type Choose one of the three types Default / FQDN / ID as remote ID
Remote WAN IP address/FQDN Enter the remote device's IP address that establishes the tunnel with the local device
Local LAN IP address / Subnet mask length Enter the subnet mask length of the local network
Remote LAN IP Address / Subnet mask length Enter the LAN pair subnet mask length
Policy protocol Choose a policy agreement, any or L2TP
Encapsulated mode IPSec has two encapsulation modes, tunnel mode and transport mode. The purpose of transport mode is to protect end-to-end secure communication. The purpose of tunnel mode is to protect some or all data between stations. Users can choose the model based on their actual needs.
NAT enabled Select to enable or disable NAT disabling
First phase
Mode The first phase of the model has two variants, one is the main mode, the other is the wild mode (also called positive mode).
Encryption algorithm 20171220041200323.pngChoose the encryption algorithm you need
Integrity algorithm There are two authentication algorithms, one is SHA‑1 and the other MD5
Diffie-Hellman Group (DH) 20171220041316767.pngChoose one of the three algorithm key models
Phase 1 SA Lifetime The SA lifecycle is 10800 by default, you can set it yourself
DPD Select to enable or disable DPD, DPD is disabled by default
The second phase
Encryption algorithm 20171220041228953.pngChoose the encryption algorithm you need
Integrity algorithm There are two authentication algorithms and the first phase, one is SHA‑1, the other is MD5
Phase 2 SA Lifetime The SA lifecycle is 10800 by default, you can set it yourself
PFS Select to enable or disable PFS, DPD is enabled by default.