Overview
1 What are the default settings for VoIP ATA devices?
1) WAN port connection type, default DHCP, as shown in the following image:
2) The following image illustrates the default LAN port setup.
3) There are two user levels, one is the user mode and the other is the admin mode. The username for user mode is user, the password is user; and the username for admin mode is admin, the password is also admin.
4) By default, line1 should be enabled and other lines disabled.
2 How to reset ATAs to factory settings?
There are three ways to reset VoIP ATAs to factory settings, two of which require a password and one that does not.
1) Reset ATAs to factory settings via the web interface
① Log in to the VoIP ATA web page, go to Administration-->Admin page;
② Press Factory Default and a web message "Please REBOOT to make the changes effective!" will appear. Please press reboot. After rebooting, all settings will return to default.
2) Reset VoIP ATAs to factory settings via IVR
① Connect an analog phone to the ATA's FXS port and press **** on the phone to enter the IVR;
② After hearing "Please enter your choice, 1 WAN port...", please select the 6 factory default settings, it requires a password, enter admin(23646) and end with #, the IVR will show "Operation successful, please...";
③ Then choose 7 Reboot, as is, the password is requested, please enter admin(23646), and the user will hear "operation successful", then the ATAs should automatically reboot and all settings return to default.
3) لا يلزم كلمة مرور لإعادة الهاتف إلى إعدادات المصنع
① Press the RST button on the ATA using a thin cable for about 10 seconds;
② All LEDs will blink, then the ATA will reboot automatically and settings will be restored.
إشعار: سيؤدي إعادة ضبط المصنع إلى إزالة جميع إعداداتك، وسيتم استعادة الجهاز إلى إعدادات المصنع الافتراضية. لا تقم بإجراء إعادة ضبط المصنع ما لم تقم بعمل نسخة احتياطية لإعداداتك أو يمكنك إعادة تكوينها مرة أخرى.
